[xep-support] graphic file formats

[Paul Slezak]

Yes, initially, but then I added -page to "convert".  I think I figured 
it out, at least for this problem.  I was "convert"ing to an image that 
was too small.  I increased the page parameters, and I now get the 
image, but  it is unacceptable. So, contrary to what I said before, the 
pstill product is working better than "convert" as it uses fonts.

I guess at this point I would like a recommendation.  My ultimate goal 
is HTML and PDF output from DocBook.  I really like how XEP does the FO 
rendering but I need better printed graphics.  I have MS Visio and the 
JPEG from it is fine for HTML. However, I am open to something else if 
it will do as good a job for HTML and a better job for printing.

TIA

Paul

Adam Rogoyski wrote:

>On Fri, 5 Sep 2003, Paul Slezak wrote:
>
>  
>
>>    I have output the image as EPS, and used "convert" to convert it to
>>PDF, yet again, I get a blank area.
>>    
>>
>
>   Are you creating a postscript file that is a full page with the
>image aligned at the bottom left hand corner?
>
>   Adam
>-------------------
>(*) To unsubscribe, send a message with words 'unsubscribe xep-support'
>in the body of the message to majordomo at renderx.com from the address
>you are subscribed from.
>(*) By using the Service, you expressly agree to these Terms of Service http://www.renderx.com/tos.html
>  
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.renderx.com/pipermail/xep-support/attachments/20030905/88a0425a/attachment.html>